Table of Contents
1. Select the More PIN_REPORT Settings...
We press this button to open up a new GUI where we can enter more configuration settings (CSETS)
Stepshot confluence view macro | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
2. Setup the PCHK_DEVICE_PIN_NUMBERS Entry
Note that this step is optional but if we don't enter them, then partBuilder will only check to see that there are the proper number of pins and that no pins have been duplicated.
If we do enter it partBuilder makes sure that every pin read from the PIN_REPORT_FILE is a valid pin number.
We use the simpler of the 2 approaches we talked about on the datasheet step
We want to tell partBuilder here what pins to expect and sometimes we need to tell it what pins not to expect.
PCHK_DEVICE_PIN_NUMBERS
In the PCHK_DEVICE_PIN_NUMBERS Entry We enter:
BGA_PIN_NUMS[A1..T3],BGA_PIN_NUMS[A7..T9]
The comma is used to split multiple commands or pin numbers here
(we could also have typed out every expected pin_number by hand but ! But that would be long boring and error-prone)
The BGA_PIN_NUMS[startRowCol:EndRowCol] is a command that partBuilder recognizes and uses to build the full array of Row/Col pins that normally appear in the Range.
It knows that most standard BGAs skip row Letters I,O,Q,S,X and Z (It also provide a way to specify what rows should be skipped if your BGA is not standard)
More Complicated Use of PCHK_DEVICE_PIN_NUMBERS and PCHK_VALID_MISSING_PINS
As discussed before we could have used BGA_PIN_NUMS[A1..T9] in the PCHK_DEVICE_PIN_NUMBERS Entry Entry to describe the FULL BGA ARRAY
and then putused
[A..T][4..6] in the PCHK_VALID_MISSING_PINS entry, and the
The combination of the 2 Entries would have created the same checks.Note that this step is optional but if we don't enter them, then partBuilder will only check to see that there are the proper number of pins and that no pins have been duplicated. If we do enter it partBuilder makes sure that every pin read from the PIN_REPORT_FILE is a valid pin number., Here its not necessary, but there are many cases where the PCHK_VALID_MISSING_PINS entry makes it very easy to modify what to expect from a full array
(For instance a BGA that has a few corner pins missing, or a BGA that has a center core power pin section, then a small rectangle of voided pins and then a huge array of outer pins...
See the PinData Verification Checks for a more complicated example
Stepshot confluence view macro | ||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
Page Properties | ||
---|---|---|
| ||
|